Doors and Locks
Homeowner Use and Maintenance Guidelines
The doors installed in your home are wood products subject to such natural characteristics of wood as shrinkage and warpage. Due to natural fluctuations of humidity and the use of forced air furnaces, showers, and dishwashers, interior doors may occasionally require minor adjustments.
Bifold Doors
Interior bifolds sometimes stick or warp due to weather conditions. Apply a silicone (not graphite) lubricant to the tracks to minimize this inconvenience.
Exterior Finish
To ensure longer life for your exterior wood doors, plan to refinish them at least once a year. Stained exterior doors with clear finishes tend to weather faster than painted doors. Treat the finish with a wood preserver every three months to preserve the varnish and prevent the door from drying and cracking. Reseal stained exterior doors whenever the finish begins cracking or crazing.
Failure to Latch
If a door will not latch because of minor settling, you can correct this by making a new opening in the jamb for the latch plate (remortising) and raising or lowering the plate accordingly.
Hinges
You can remedy a squeaky door hinge by removing the hinge pin and applying a silicone lubricant to it. Avoid using oil, as it can gum up or attract dirt. Graphite works well as a lubricant but can create a gray smudge on the door or floor covering beneath the hinge, for this reason we do not recommend the use of graphite lubricants, such as WD-40.
Keys
Keep a duplicate privacy lock key where children cannot reach it in the event a youngster locks him- or herself in a room. The top edge of the door casing is often used as a place to keep the key. A small screwdriver or similarly shaped device can open some types of privacy locks.
Locks
Lubricate door locks with graphite or other waterproof lubricant. Avoid oil, as it will gum up.
Slamming
Slamming doors can damage both doors and jambs and can even cause cracking in walls. Teach children not to hang on the doorknob and swing back and forth; this works loose the hardware and causes the door to sag. Some doors have hinge bumpers; using too much force when opening these doors can drive the bumper into the wood frame or into the door, resulting in damage.
Shrinkage
Use putty, filler, or latex caulk to fill any minor separations that develop at mitered joints in door trim. Follow with painting. Panels of wood doors shrink and expand in response to changes in temperature and humidity. Touching up the paint or stain on unfinished exposed areas is your home maintenance responsibility.
Sticking
The most common cause of a sticking door is the natural expansion of lumber due to changes in humidity. When sticking is due to swelling during a damp season, do not plane the door unless it continues to stick after the weather changes.
Before planing a door because of sticking, try two other steps: first, apply either a paste wax, light coat of paraffin, or candle wax to the sticking surface; or second, tighten the screws that hold the door jamb or door frame. If planing is necessary even after these measures, use sandpaper to smooth the door and paint the sanded area to seal against moisture.
Warping
If a door warps slightly, keeping it closed as much as possible often returns it to normal.
Weather Stripping
Weather stripping and exterior door thresholds occasionally require adjustment or replacement.
GOODIER BUILDERS Limited Warranty
During the orientation we confirm that all doors are in acceptable condition and correctly adjusted. GOODIER BUILDERS will only repair damage to doors noted on the orientation list.
Adjustments
Due to normal settling of the home, doors may require adjustment for proper fit. GOODIER BUILDERS will make such adjustments.
Panel Shrinkage
Panels of wood doors shrink and expand in response to changes in temperature and humidity. Although touching up the paint or stain on unfinished exposed areas is your home maintenance responsibility, GOODIER BUILDERS will repair split panels that allow light to be visible.
Warping
GOODIER BUILDERS will repair doors that warp in excess of ¼ inch.